| .首页 .汽车电路图 .手机电路图 .mp3电路图 .功放电路图 .主板电路图 .显示器电路图 .电磁炉电路图 .开关电源电路图 .电视机电路图 .收音机电路图 .电源电路图 .充电器电路图 .耳机电路图 .滤波电路 .遥控器电路图 .usb电路 .放大电路 .防盗报警器 .振荡电路 .控制电路 .脉冲电路 .保护电路 .电话机 .LED电路 .电饭堡电路 .热水器电路 .传感器电路 .小家电电路 .温度计 .电动自行车 |
上篇:4管发射机原理图
下篇:具有稳幅环节的RC桥式振荡电路

his was one of the earliest circuits that I ever designed and built, in Spring 1982. At that time I had only an analogue meter and a calculator to work with. Although far from perfect, this amplifier does have a wide frequency response, low distortion, and is capable of driving an 8 ohm speaker to output levels of around 5 watts with slightly higher distortion. Any power supply in the range 12 to 18 Volts DC may be used.
Circuit Description
The amplifier operates in Class AB mode; the single 470R preset resistor controls the quiescent current flowing through the BD139/140 complimentary output transistors. Adjustment here, is a trade-off between low distortion and low quiescent current. Typically, under quiescent conditions, standby current may be 15 mA rising to 150 mA with a 50 mV input signal.
相关电路图
Copyright © 2005 - 2008 电子电路图网