| .首页 .汽车电路图 .手机电路图 .mp3电路图 .功放电路图 .主板电路图 .显示器电路图 .电磁炉电路图 .开关电源电路图 .电视机电路图 .收音机电路图 .电源电路图 .充电器电路图 .耳机电路图 .滤波电路 .遥控器电路图 .usb电路 .放大电路 .防盗报警器 .振荡电路 .控制电路 .脉冲电路 .保护电路 .电话机 .LED电路 .电饭堡电路 .热水器电路 .传感器电路 .小家电电路 .温度计 .电动自行车 |
上篇:过零脉冲电路(实验验证过)
下篇:2W 音频放大器

Circuit Notes
This circuit provides an FM modulated signal with an output power of around 500mW. The input
Mic preamp is built around a couple of 2N3904 transistors, audio gain limited by the 5k preset.
The oscillator is a colpitts stage, frequency of oscillation governed by the tank circuit made from
two 5pF capacitors and the inductor. ( Click here for Colpitt Oscillator Resonant Frequency Equation.)
Frequency is around 100Mhz with values shown.
Audio modulation is fed into the tank circuit via the 5p capacitor, the 10k resistor and 1N4002
controlling the amount of modulation. The oscillator output is fed into the 3.9uH inductor which
will have a high impedance at RF frequencies.
The output stage operates as a class D amplifier , no direct bias is applied but the RF signal developed
across the 3.9uH inductor is sufficient to drive this stage. The emitter resistor and 1k base resistor
prevent instability and thermal runaway in this stage.
Paul K. Sherby
Belleville,
Michigan.
USA
Website- httpwww.geocities.comEurekaPark5323
相关电路图
Copyright © 2005 - 2008 电子电路图网