| .首页 .汽车电路图 .手机电路图 .mp3电路图 .功放电路图 .主板电路图 .显示器电路图 .电磁炉电路图 .开关电源电路图 .电视机电路图 .收音机电路图 .电源电路图 .充电器电路图 .耳机电路图 .滤波电路 .遥控器电路图 .usb电路 .放大电路 .防盗报警器 .振荡电路 .控制电路 .脉冲电路 .保护电路 .电话机 .LED电路 .电饭堡电路 .热水器电路 .传感器电路 .小家电电路 .温度计 .电动自行车 |
The soft switching is enabled by a BD131 transistor wired as a switch in emitter follower configuration. The collector is wired to a permanent supply voltage, the 2H series inductor serves only to filter out power supply hum. This inductor is not too important and may be omitted if the DC supply is adequately smoothed. The control voltage is applied to the BD131 base terminal, the 10u capacitor and 10k resistor having a dual purpose:-
i) a gradual charge of the 10u capacitor ensures that the transistor will switch linearly from 0 volts to full supply, and
ii) serves as a hum filter ensuring a very smooth dc supply to the amplifier and tone controls.
LED1 will light when the amplifier is on. The control voltage should ideally be 0 volts when the amplifier is off and full supply voltage when on. The LM380 is shown driving two 8 ohm loupspeakers, the load is therefore 4 ohms. The 4u7 capacitor acts as a crude crossover, lower frequencies are impeded and so this loudspeaker may be a "tweeter" type.
相关电路图
Copyright © 2005 - 2008 电子电路图网